Johnson Service Bulletin SB-1199 - Trailing Motors with the Use of a Tilt Lock

Issued June 1969, this bulletin warns that a tilt lock is not a trailering support. Johnson recommends transporting the motor in its normal running position, or using a suitable support bracket when road clearance requires a semi-tilted position.

Johnson Motors Service Bulletin factory letterhead

June, 1969

SUBJECT:TRAILING MOTORS WITH THE USE OF A TILT LOCK

ON MODELS:TR(L)10S, 55ES-ESL69
All Current V4 Engines

We have had a few field reports of tilt locks being used as a trailing lock. The tilt lock will hold the motor in a full tilt position for launching, loading or beaching the boat but will not hold the motor in a tilt position while trailing.

When trailing a boat we recommend that the motor be in its normal running position. If the trailer construction does not provide adequate road clearance, the use of a bracket designed for supporting the motor in a semi tilt position is recommended. Contact your trailer manufacturer or boat and motor accessory manufacturer.

In your Parts Catalogs and Service Bulletin #1194, we use the word trailing lock which should read tilt lock.

When it is evident that the tilt lock has been used for trailing purposes, no warranty will be considered.

JOHNSON MOTORS

Doug Cankar

Doug Cankar
Administrative Assistant

DC:rm

NOTE:  Post on your Miscellaneous Index under the heading "Lower Unit."

Historical reference

Johnson Service Bulletin SB-1194 - SB-1199 corrects the term “trailing lock” used in this earlier bulletin to “tilt lock.”

For historical reference only. Consult current manufacturer instructions for safe transport and support of an outboard motor.