Back to previous page

SB-1350 - Service Tips: Tilt-Assist Shock Absorbers

Issued July 1974, this Johnson Service Bulletin explains identification and servicing of tilt-assist shock absorbers on 1975 Johnson 70 through 135 H.P. outboards. The original two-page factory text is reproduced below.

Johnson Service Bulletin factory letterhead
SB-#1350
July, 1974
SUBJECT: Service Tips - Tilt-Assist Shock Absorbers
ON MODELS: 70ESL75, 75ESLR75, 85ESL75, 115ESL75 and 135ESL75

Beginning with the 1975 model year, the engines listed above will be equipped with pressurized shock absorbers which greatly ease the physical effort required to tilt the engine. Listed below is some general information which should be kept in mind when mounting one of these engines or when servicing the shock absorber.

1. THE ENGINE'S TILT LOCK LEVER MUST BE IN THE "RUN" POSITION whenever the engine is lifted by the lifting eye. If the lever is in the "tilt" position, the stern bracket will swing out making it difficult to install the engine on a boat or motor stand.

2. The shock absorbers are sealed and cannot be repaired or repressurized. A loss of pressure will not affect the shock absorbing function as long as the oil is not lost. It will only affect the ease with which the engine can be tilted.

3. There are two pressurized and one non-pressurized shock absorbers in use on 1975 engines. These are similar in appearance but can be identified as follows:

PART NO.USED ONIDENTIFICATIONREMARKS
38675575ESL75
75ESLR75
Stamped with part number 386755. 1" wide green paint band.Pressurized
38675685ESL75
115ESL75
135ESL75
Stamped with part number 386756. 1" wide red paint band.Pressurized
385532115ESL75
135ESL75
Stamped with part number 385532. No paint band.Non-Pressurized
(over)
PAGE 2SERVICE BULLETIN   SB-#1350
JOHNSON OUTBOARDS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085

4. If a customer wishes to reduce or eliminate the tilt-assist feature, one or two of the non-pressurized shock absorbers (P/N 385532) can be installed. On V4 engines, the amount of tilt-assist can also be reduced by installing shock absorbers from the 70/75 H.P. Under no circumstances should V4 shock absorbers be installed on 70/75 H.P. engines since this would increase the amount of tilt assist to the point where the engine might not return to water after impact with a submerged object.

JOHNSON OUTBOARDS

D. J. Leinonen

Technical Data Coordinator

DJL/sn

NOTE: Post on your 70 thru 135 H.P. indexes under the heading
"Lower Unit".

Related: SB-1346 - Lubrication of Tilt Tube (steering system service).

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Power Trim & Tilt Hydraulic Fluid & Spanner Wrench

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 386755

Search for original or compatible replacement part 386755. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.