2009-01(S) - Service Tools - 2009 Model Year
January 30, 2009 Evinrude/Johnson service bulletin describing factory tools introduced for 2009 outboards, including E-TEC 25 and 30 HP applications and gearcase servicing equipment.

New service tools have been developed during the 2009 Model Year. These tools will NOT be shipped automatically as part of the essential tool program and must be ordered as needed. Refer to the appropriate service manual for the required service procedures.
354717 Engine Lift Kit: Used to lift 25 HP and 30 HP Evinrude E-TEC outboards from shipping carton. Once the outboard is lifted, the engine cover can be easily removed. (Refer to “Predelivery Bulletin 2008-02(D) and predelivery and installation instructions for additional information.)

354719 Stator Test Adaptor: Used on 25 HP and 30 HP Evinrude E-TEC models to test stator output.

354720 Wrist Pin Retainer Installation Tool: Used to install the wrist pin retainer in piston on 25 HP and 30 HP Evinrude E-TEC outboards.

587005 Diagnostic Power Supply: Used to supply 12V for communication and programming on Evinrude E-TEC outboards. Originally developed for use on Evinrude E-TEC 25 - 65 HP rope start models. Can be used on Evinrude E-TEC outboards or Evinrude DI outboards.
IMPORTANT: DO NOT connect this diagnostic power supply to a running outboard.

321428 Bearing Installer: This tool was originally released prior to 2001. Use this tool to service new 25 and 30 HP Evinrude E-TEC outboards. Used to install front propeller shaft bearing on 20 - 35 HP outboards.
335820 Bearing Installer: This tool was originally released prior to 2001. Use this tool to service new 25 and 30 HP Evinrude E-TEC outboards. Used to install rear propeller shaft bearing 20 - 35 HP outboards.

2. Bearing installer, P/N 335820
354718 Alignment Gauge Puller: Used to remove propeller shaft bearing housing and alignment gauge from gearcase housing on “L2” or “M2” type gearcases. Alignment Gauge Puller, P/N 354718, Alignment Gauges, P/N 5007749 or P/N 5007750, and Gearcase Alignment Gauge Kit, P/N 5006349, are used to check a gearcase housing for damage.
