Johnson Service Bulletin SB-1104 - Overheating

September 1966. Factory service guidance for JW and JH 3 HP, LD 5 HP, and CD 5½ and 6 HP engines. Covers water tube grommet deterioration and revised adapter plate gasket water passage dimensions.

Johnson Motors Service Bulletin letterhead

September, 1966

SUBJECT:  OVERHEATING
ON MODELS: JW, JH-19 thru 21
     LD-10 thru 11
     CD-16 thru 23

Overheating and water pump failure are often synonymous. While it is generally a good idea to check out the water pump components and related water passages, it is also important to remember certain points and changes in other areas of the motor which can cause overheating.

In this bulletin we want to acquaint you with two problems we have found existing in the subject models.

1. The upper end of the water tube has been anchored to the powerhead adaptor plate by means of a rubber grommet on all 1964 thru 1966 3 H.P. and 1965 and 1966 5 H.P. engines. (See Figure 1.)

This grommet is in constant contact with the engine exhaust and as a result can deteriorate, causing overheating problems.

CAUTION: When reinstalling the powerhead, be certain this grommet is positioned properly.

Figure 1, water tube grommet position on outboard engine
Figure 1

2. Another area which deserves inspection in cases of overheating is the gasket between the powerhead and the adaptor plate. Service Bulletin #1079 details the possible mix-up that can be made on 3 H.P. models JW and JH-19A thru 21E. On the subject LD and CD models this gasket has been changed to increase the diameter of the water passage hole. As you will note in Figure 2, #306205 Gasket has a 5/32" diameter hole compared to the improved #313065 Gasket which has a 5/16" diameter hole. We suggest you rework your present inventory of #306205 Gaskets by simply increasing the size of this hole to 5/16" using an appropriate tool.

PAGE 2    SERVICE BULLETIN   SB-1104
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
Figure 2 comparing gasket 306205 with 5/32 inch hole and gasket 313065 with 5/16 inch hole
Figure 2

After the cause of overheating has been found and corrected, always replace the cylinder head and exhaust cover gaskets.

JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

CK/rkm

NOTE: Post on your JW and JH 3 H.P., LD 5 H.P. and CD 5½ and 6 H.P. Indexes under the heading "Powerhead".

Historical parts and service references

306205: Original adapter plate gasket with 5/32-inch cooling-water passage hole. 313065: Improved gasket with 5/16-inch passage hole. Johnson recommended enlarging existing 306205 gasket inventory to 5/16 inch.

Related bulletin: SB-1079, addressing gasket identification on JW and JH 3 HP models.