Johnson Service Bulletin SB-1128 (May 1967)

Lubrication Fittings: Swivel Brackets, Shift Linkage, Etc. Johnson announced a transition from press-in grease fittings to threaded fittings on all models, with drilling, tapping, and installation instructions.

Johnson Motors Service Bulletin letterhead

May, 1967

SUBJECT:LUBRICATION FITTINGS:
SWIVEL BRACKETS, SHIFT LINKAGE, ETC.

ON MODELS:  ALL MODELS

Already in effect is a program to "phase out" the press-in type lubrication fittings. As time progresses, these fittings will all be replaced with threaded fittings.

The threaded fitting, P/N 313607, can be installed wherever required by drilling out the present hole with a #3 drill and tapping with a 1/4"-28 thread tap. DO NOT DRILL HOLE LARGER THAN #3 DRILL SIZE. The threaded fitting should then be installed and torqued to 3 - 5 foot pounds.

JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

CK/rkm

NOTE:  Post this bulletin on all Indexes under the heading "Miscellaneous".

SPECIAL NOTE:  SB-1120 and 1121 got out without posting instructions. Post SB-1120 to your RD, RK - 40 H.P. Index under the heading "Electrical" and Miscellaneous Index under the heading "Accessories". Post SB-1121 to all Indexes pertaining to 1967 models under the heading "Miscellaneous".

Historical parts and bulletin references

313607: Threaded lubrication fitting replacing the press-in style. Factory installation: #3 drill, 1/4"-28 tap, 3-5 ft-lbs torque.

Related bulletins: SB-1120 and SB-1121 (indexing instructions).