Johnson SB-996 Rev. 1 - Timing and Synchronizing V4M(L) 90 HP Engines

February 1965. Factory timing and synchronization instructions. The marked-out procedure on page 2 refers to supplemental bulletin SB-996A.

Related factory bulletin: SB-996A.

Johnson Motors service bulletin letterhead
SB-#996 Rev. #1 Destroy SB-#996 dated 12/2/63
February, 1965
SUBJECT: TIMING AND SYNCHRONIZING V4M(L)-90 HP ENGINES
Timing and synchronizing procedures for the 90 H.P. engine are similar to those used on previous 75 HP models. Flywheel timing marks have been relocated for ease of alignment.
Timing - To be sure distributor is properly timed with the crankshaft, proceed as follows:
Step 1 - Align the punch mark (painted red) on the flywheel with the arrow on the ring gear guard marked "belt timing" (figure 1).
Figure 1 flywheel timing alignment
Figure 1
Step 2 - Notch in distributor drive pulley rim should be aligned with timing line on distributor bracket (figure 2).
If mark and notch do not line up, loosen distributor bracket screws (3) and reset drive pulley. Place tension on belt and retighten screws. Correct belt tension will allow a deflection of 5/16 to 3/8 inch with a 1 lb. load near the center of the belt.
Figure 2 distributor drive pulley notch
Figure 2
PAGE 2 SERVICE BULLETIN SB-#996
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60086
Factory page annotation SEE SB 996A crossing out synchronizing instructions, Figures 3 and 4 together
Step 3 - Check the pickup position of the throttle with the cam. The roller should begin to open the throttle as the center of the roller shaft aligns with the mark on the cam (Figure 5). If this adjustment is incorrect, loosen screw "A". Push throttle arm "B" toward cam (figure 6) and while holding roller in contact with throttle cam, re-tighten screw "A". Center of roller shaft must be in alignment with cam timing mark during this adjustment Re-check adjustment.
Figure 5 cam roller timing mark, screws A and B
Figure 5
PAGE 3 SERVICE BULLETIN SB-#996
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60086
Figure 6 throttle cam adjustmentFigure 7 control shaft bracket and throttle rod
Figure 6
Figure 7
Step 4 - Move throttle control shaft to full throttle position. The control shaft arm should be against its stop on the control shaft bracket, (arrow 2, figure 7) and throttle arm "B" should be against its stop on the carburetor casting (arrow 1, figure 7). If either of these are not against their respective stops, remove pin "C" (figure 7) and adjust throttle control rod clevis "D" until these settings are possible. Replace pin, washers and cotter pin.
JOHNSON MOTORS
Jack Penland Service Promotion Manager
RC:eb
NOTE: Post on your V4-90 HP Index under the heading "IGNITION".