
March, 1967 SB-1122
SUBJECT: INCORRECT SPARK PLUG SPECIFICATION
ON MODEL: V4TL-13, 100 H.P.
Early production 1967 100 H.P. models incorrectly specified on the starting instruction transfer, the use of Champion J4J spark plugs. The only plug recommended for use with the Johnson Power Pulse capacitor discharge ignition is the surface gap, Champion L-19V.
You may have been advised that Champion J4J or Autolite A21X or AC M42K gapped at .040" could be used in emergencies. This can be done, but only for a limited time. These plugs have a 3/8" reach and leave 1/8" of thread exposed in the cylinder head. Carbon build-up in these threads can cause damage when the recommended L-19V is again installed. If such a condition exists, chase out the threads with a 14mm spark plug tap before installing new plugs.
Replacement transfers are available at no charge through the factory Service Department for those motors built prior to serial #2718046. Application of these transfers requires using #277409 Transfer Solution which is available through your Parts Distributor.
Use the enclosed order blank for ordering your requirements of 1967 V4TL Starting Instruction Transfers.
Carl Klawonn
Administrative Assistant
CK/rkm
NOTE: Post on your V4M-100 H.P. Index under the heading "Ignition".
Factory page 1