Johnson Service Bulletin SB-1126 - Voltage Suppressor

April 1967. Johnson Motors advised dealers to retrofit earlier 1967 V4TL-13 100 H.P. outboards with voltage suppressor kit #580687 to protect the Power Pulse ignition Pulse Pack against alternator voltage surges.

Johnson Motors Service Bulletin letterhead

April, 1967 SB-1126

SUBJECT:   VOLTAGE SUPPRESSOR

ON MODELS:  V4TL-13, 100 H.P.

Approximately December 1, 1966, we added a voltage suppressor on the 1967 100 H.P. model V4TL-13. This suppressor is wired into the red input lead to the Pulse Pack and is mounted on the starboard side of the Pulse Pack bracket.

The purpose of the voltage suppressor is to protect the Pulse Pack circuitry against voltage surges and excessive voltage created by an uncontrolled alternator output; these conditions usually being caused by loose connections.

To protect your customers against ignition failure, motors produced prior to serial number J2719405 should be brought up to date by adding a #580687 Voltage Suppressor Kit.

Installation is very simple; all parts and instructions are included in the kit. Voltage Suppressor Kits are to be ordered from your Parts Distributors. Regular Credit Voucher procedure will be followed upon our receipt of a Warranty Claim to this effect. Be certain to include model and serial numbers and all other pertinent information requested on the Warranty Claim.

JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

CK/rkm

NOTE:  Post on your V4M 100 H.P. Index under the heading "Ignition".

Factory page 1

Historical reference

The retrofit described in SB-1126 applies to early-production 1967 V4TL-13 100 H.P. engines, prior to serial number J2719405. The bulletin identifies voltage suppressor kit #580687 and describes the original warranty-claim procedure.