May 1967. Johnson corrected a sensor mounting problem on 100 H.P. V4T(L)-13 engines by adding a flat washer and a longer retaining screw, preventing the star washer from shifting the sensor during adjustment.
Johnson Motors Service Bulletin letterhead

May, 1967

SUBJECT:SENSOR RETAINING SCREW P/N 510328
(Item #13, page 8 of 1967 V4TL-13 Parts Catalog)
ON MODELS:V4T(L)-13 - 100 H.P.

Adjustment of the Sensor is hindered by the star washer on the subject screw which tends to cause the Sensor to move as the screw is tightened.

To eliminate this problem, a flat washer, P/N 303952, has been added between the star washer and Sensor base along with a longer screw, P/N 510193.

Since Screw #510328 was used in two applications within the Distributor (Sensor Retainer and clamp to plate), it would be to your advantage, for future reference, to correct your parts catalog, item #13 pertaining to Sensor mounting, to show the new parts as listed above.

Correct Sensor adjustment is mandatory to good engine performance. Utilize the new parts which will aid you in making accurate Sensor gap settings.

JOHNSON MOTORS
Carl Klawonn
Administrative Assistant
CK/rkm

NOTE:  Post on your V4M 100 H.P. Index under the heading
      "Ignition".
Historical parts reference: Sensor retaining screw 510328; replacement longer screw 510193; added flat washer 303952. See also SB-1111 - Introduction to the Capacitor Discharge Ignition System for sensor adjustment and ignition-system background.